Help with integrating an exsisting profile

[trigger638]

Hello,

I recently purchased MachStdMill and im trying to figure out how to integrate my setup without having to do it manually. I have a configuration (xml) file that i recieved with my mill that sets up all of the settings. When installed it comes up as a profile. So since MachStdMill also comes up as a profile i cant use both. So my question is how can i integrate the two so I can use MachStdMill without the hours it would take to match up all my settings?

Thanks

[DaveCVI]

Hi,
The MSM readme file tell how to clone an existing profile for use with MSM.
The readme file can be found in C:\Mach3\Documentation\MachStdMill/MachStdMIll README.pdf
In particular you want section 3.2.12.1

Dave