gui not in step

[StuartH]

Dave

This may have been like this all the time

on the run page the two windows that show the tool path are not in sync

the path page was OK but the the run was offset

the tool was in the same relative position but the tool path was off set

because of the improved tool handling and probing as we have discussed my work ( hobby ) flow as changed for the better i may add so i now do not region the tool paths

it was a bit disconcerting as i had started the run from the path page and then switched to the run tab and the tool path was offset


maybe its me not doing thing correctly
system Win 7 64 bit ( ugg I no likey the rest on my computers are macs ) but mach only runs on a win doze machine

Stuart

[DaveCVI]

Alas, not much I can do about this one. The path display is a screen widget that is controlled and refreshed by mach. All I can do is place it someplace on the screen page. I have noticed before that changing screen set pages will throw the path display off - but I think that will have to be considered as "just another mach3 bug" that will not be fixed (Artsoft USA has refused to do any work on mach3 for a couple of years now).
Dave

[StuartH]

Dave
Thanks for the info I suspected as much

its my new work flow that has shown it up

Stuart