D2NC software with Machstdmill

[Cemlhh]

D2NC software used to input g code into mach3 and can I do that with machstdmill. I know nothing about adding buttons or what I really need to do to make this work. Any help would be great. Thanks

[DaveCVI]

Hi,
With a little bit of script configuration MSM will automatically load D2NC for you via a button on the load page.
See user manual section 3/1/2/8 for the G-Code Utility Button that is on the load page of MSM.
Then see section 15.9.2.2 for tech details of how to set the button up to run D2nc.
It involves copying a script from one place to another, changing it's name and editing the new script to comment out one line and un-comment another.

Dave

[Cemlhh]

Thank you