Page 1 of 1
running tool setter and touch probe on separate inputs
Posted: Sun Mar 05, 2017 6:07 pm
by 1hander
i have the touch probe setup on one channel of course..and working properly.... right now when i activate the probe the toolsetter light comes on as well....
can i set the tool setter to a separate input so the toolsetter is separate from the touchprobe..
Re: running tool setter and touch probe on separate inputs
Posted: Mon Mar 06, 2017 7:44 pm
by DaveCVI
Please sec section 6.3.1.x of the Mill user manual.
Dave
Re: running tool setter and touch probe on separate inputs
Posted: Tue Mar 07, 2017 12:20 pm
by 1hander
thanks for the wakeup dave...its been a while since i looked at the manual...as soon as i looked at the section it all came back... to be honest the NC toolsetter i was using was giving me great results...variations in tool height measurements of +-.0002.... i can live with it... i will put it back the way it was... and move one to adding rpm board and hooking the vfd up to c62 so i dont need the vfd plugin anymore...hoping to do rigid tapping on the mill...
thanks for the reply dave