Calypso CNC User Forums

mbam wrote:I just downloaded & installed MSM Personal edition however now my Mach 3 wont run, even with my old profile.

mbam wrote: Error triggered Art Code 20070911 , theattemptmt recovery and get error code 9991 which repeats until I say no to attempt recovery, then error stopping timer, then Mach crashes completely.

Any ideas?

Thanks!!

DaveCVI wrote:Hi,
please see below -
And I do need the minimum info re mach & win version etc - see:
http://www.calypsoventures.com/forums/v ... hp?f=4&t=5

mbam wrote:I just downloaded & installed MSM Personal edition however now my Mach 3 wont run, even with my old profile.

1) When installing, did you follow the readme instructions and thus created a copy of the non-MSM profile and then used the copy to run MSM?
If you did, then when you say "even with my old profile" - you mean the one that was not changed by MSM?

mbam wrote: Error triggered Art Code 20070911 , theattemptmt recovery and get error code 9991 which repeats until I say no to attempt recovery, then error stopping timer, then Mach crashes completely.

Any ideas?

Thanks!!

I have no idea what the "art codes" mean- Art once told me that they were intended to be internal codes for his use only. I don't know of any list of art codes that tells what they mean in human terms. Hum, I've never seen a case where an MSM personal install would start creating Art codes. If that happened to me, I'd reinstall mach as it sounds as if something has gone seriously awry.

Dave

mbam wrote:...I am pretty sure there is something else that is not related to MSM going on. ...