Calypso CNC User Forums

i have machstdmill and used it on a denford router, ive sold that router but kept the laptop as i wanted to retain my mach3 and machstdmill licenses.

got a new machine and ive been sent a mach3 xml file. when i open the new profile, its just standard mach3 and not machstdmill screen.

how do i change the screen to machstdmill?

Hi,
You essentially have a new system with MSM partially installed on the PC. I suspect you have run the installer, but not done the steps to make a Mach profile which starts and runs MSM.
Please go to C:\Mach3\Documentation\MachStdMill and open the MachStdMIll README.pdf file. Follow the instructions there to make a cone of your stock Mach profile and then set the cloned profile to use MSM.
Dave