Calypso CNC User Forums

I'll probably re-up my license this evening. I'm not sure if I .12 will help, but since you provide reliable support I should provide reliable funding.

Log sent.

I'm on 2.3.6. When I tried to update to 2.3.12 it tells me my license isn't valid.

Hi Dave, I hate to be a pain again, but I'm experience some issues. I switched from the ESS to UC300eth controller. I wanted to gain access to UCCNC but also keep my handy dandy Mach Std Mill setup because I know how to use it and have had excellent results machining with it. Long story short, after...

Epic!

Embarrassingly (on my part, i should have done my research) easy!

Happy holidays and thanks as always!

I'm nearing the completion of my trunnion table with c axis. At a minimum I need to add that into the WC Offset panel for zeroing. I'm not proficient in VB but I assume that's what I'll need to do. Is there an easy way of achieving this?

Well, running sans gas spring was a failure. I couldn't audibly detect step loss but after a tool crash and a some analysis it's obvious that it did occur. I guess two years ago when I installed it because I believed the machine would benefit I was on the right path. Reinstalling it and trying again...

I figured this one out. After running the scenario through my head many many times the only conclusion I could come to is that it was a geometry issue, specifically that of the milling machine itself. Though I had recently trammed the mill and squared the head I knew something had to of moved. So ye...

Well after further playing I'm at a loss. The prob tip has .0001" runout, the probe body has less than .0005" runout. The repeatable holder and spindle are both under .0001" runout. I probe a hole to find center, the op runs. I manually run the spindle up, change the tool, no X or Y m...

So I was digging around in the forum and I see that in May of last year another posted a similar issue, though he identified his issue to be a controller or plugin of some variety. I'm using ESS so I don't think my problem is there. That said, I know my tip wear compensation for my probe is around ....

Hi Dave, I have an issue that I thought was cam related but am realizing it's related to something else. After I run a probe routine to find a hole center and then mount a new tool (M6t16 for example where as probe is M6T101) and then enter X0Y0 and then lower the tool to the hole the tool is obviou...